Dental Problems

Luster Teeth Whitening Instructions

dental care and womenThe luster teeth whitening product consists of a moldable tray which holds the whitening gel in it. The gel helps to clean and remove the stains from the teeth. One should ensure that the tray is properly molded so as the whitening gel directly comes in contact with the teeth surface, providing maximum effects on the teeth. It is important to follow the instructions or directions while you use the luster teeth whitening product.


  1. Use warm water to rinse the modable trays. Take a pot and add hot water about five inches. Place the pot on the stove and allow the water to bring to a boil.
  2. Now place the moldable tray, the upper one in the mouth and push it against the teeth. Press against the tray with the teeth and pull it down with the tongue as one sucks it inward. Continue pulling with the tongue and practice it until you feel that the tray is pulled against the teeth. You should repeat the process in a similar way with the lower or bottom moldable tray.
  3. While the water in the pot is boiling, turn off the flame and allow it to stop boiling. By the forward tab, hold or grasp the top tray. Lower the moldable tray in the hot water. You may count up to five and then remove the moldable tray from the pot and place it against the upper teeth. To mold the moldable tray on the teeth, pull it down with the tongue. If it fits snuggly against the teeth, trim the tab with scissors from the tray. Repeat the process with the lower or bottom moldable tray.
  4. Place a small amount of whitening gel in each of the tooth depression of both the trays. Press these trays with the teeth and allow it remain for about 15 minutes.
  5. Remove them (moldable trays) from the mouth and immediately brush the teeth with a toothbrush and a toothpaste.
  6. Lastly, rinse the moldable trays with water.

These are a few instructions while using luster teeth whitening.

Leave a reply

Your email address will not be published. Required fields are marked *